-19-
Remove Felt Packing (A)
[13]
from the assembly parts and insert the tip of the bearing puller’s hook into
the space between Ball Bearing 6905DDUCMNS7S
[14]
and Washer (A)
[70]
. In this state, stand Cylinder
[21]
upright, then use a hand press to push the end face of Cylinder
[21]
and then demount Ball Bearing
6905DDUCMNS7S
[14]
. You can then separate Washer (A)
[70]
, Lock Spring
[16]
, Lock Sleeve
[17]
,
Washer (B)
[67]
, and Slide Sleeve
[19]
. Cylinder
[21]
and other parts may pop up under spring pressure
when you demount Ball Bearing 6905DDUCMNS7S
[14]
. Therefore, be very careful.
Hook of bearing puller
Ball Bearing 6905DDUCMNS7S
[14]
Washer (A)
[70]
Cylinder
[21]
Hand press
Lock Sleeve
[17]
Lock Spring
[16]
Washer (B)
[67]
Slide Sleeve
[19]
