-20-
(b) Components in the Cylinder
Remove Striker
[30]
from inside of separated Cylinder
[21]
. Then insert a punch (or thin but rigid material)
into the inspection hole of Cylinder
[21]
, hammer Stopper Ring
[29]
to move it from the groove in Cylinder
[21]
in the arrow direction. Use a spring hook (J201, No.970977) to pull out Stopper Ring
[29]
from the
groove in the arrow direction. You can then remove Damper Holder (B)
[28]
, Damper Holder (A)
[26]
, O-
Ring (A)
[27]
, Damper (B)
[25]
, Damper Washer
[24]
, and Second Hammer
[23]
from Cylinder
[21]
.
(c) Piston
Piston
[36]
remains in Crank Case
[104]
. Turn Crank Shaft
[106]
, move Piston
[36]
toward the lower dead
end, then remove Connecting Rod
[37]
from Crank Shaft
[106]
and remove the piston assembly.
Cylinder
[21]
Punch etc.
Stopper Ring
[29]
Spring hook
Second Hammer
[23]
Damper Washer
[24]
Damper (B)
[25]
O-Ring (A)
[27]
Damper Holder (A)
[26]
Damper Holder (B)
[28]
Piston
[36]
Crank Case
[104]
Crank Shaft
[106]
Connecting Rod
[37]
Crank Case
[104]
Crank Shaft
[106]
Connecting Rod
[37]