156
A
dd
itio
na
l In
fo
rm
at
io
n
Disc cover cannot be
closed.
Is the disc correctly inserted?
Remove the disc and then reinsert it.
41
Connect a fully charged battery or AC adapter/charger,
and then turn the camcorder on and try again.
23, 45
Operating noise is
heard.
This is not a fault. A quiet operating sound is heard as the
disc rotates during recording or playback, etc.
—
Some vibrations are
felt or slight sound is
heard from
mechanism.
These vibrations or sound are caused by HDD/disc drive.
This does not indicate a fault.
—
•
No operation can
be performed
because the
ACCESS/PC or
CARD ACCESS
indicator on this
camcorder remains
lit or flashing.
•
After a disc or
card is inserted, it
takes some time
until recording is
possible.
In the following cases, it will take more time than usual
until operation is possible:
•
Immediately after a disc or card is inserted.
•
When a long time has elapsed since the camcorder was
turned off last.
•
When the temperature is greatly different from the
status of previous recording.
•
When a scratched or dirty disc is inserted.
•
When the camcorder is subjected to strong vibrations.
•
When the battery or DC power cord was disconnected
before turning the power switch off.
—
No image in the
viewfinder.
•
Is the LCD monitor open?
No image will appear in the viewfinder unless the LCD
monitor is closed (default setting). You can change this
setting.
•
Is the camcorder set to the sleep mode?
Press
QUICK START
to release sleep mode.
21, 48
No image appears on
the LCD screen or in
the viewfinder.
•
Is the camcorder set to sleep mode?
Press
QUICK START
to release sleep mode.
•
In playback mode, did the last scene viewed end in a
wipe to black edit?
Press
DISC NAVIGATION
.
•
Is camcorder connected to PC?
Unplug the PC connection cable.
48, 109, 127
Symptom
Cause and Correction
Reference
page