5 - 8
(7) MAN Circuit Board and Rear Block
Information:
Before replacing the MAN circuit board, refer to “5-4
EEPROM data backup and write”.
1) Remove the hand strap (c) from R case (d).
2) Disconnect the fl at cable.
3) Remove the three screws [A].
4) With DZ-GX3300E/GX3200E, remove the SHE-H circuit
board (e) from the MAN circuit board (a)
in the direction of the arrow.
5) Remove the GSL-3M/2M/1M/L circuit board (f) from
MAN circuit board (a) in the direction of the arrow.
6) Remove the three screws [C].
7) Remove the MAN circuit board and rear block (b),
respectively, in the directions of the arrows. The MAN
circuit board is directly connected to a circuit board on
the disc drive unit (g) via connector, so be sure to remove
it in the direction of the arrow.
8) Disconnect the two fl at cables.
Caution during disassembly and reassembly:
Securely connect the MAN circuit board (a) and the
circuit board on disc drive unit (g).
3) [A]
3) [A]
1)
(c)
3) [A]
3) [A]
2)
8)
(b)
(c)
(e)
(f)
(d)
(g)
(a)
Unlock
Pull out
7)
7)
1)
5)
6) [C]
4)
[C] M1.7×3
(Silver)
[A] M1.7×4
(Silver)
Fig. 5-3-7
Right side
Disassembly and Reassembly > Disassembly
(a) MAN circuit board
(b) Rear block
(c) Hand strap
(d) R case
(e) SHE-H circuit board
(f) GSL-3M/2M/1M/L circuit board
(g) Disc drive unit
