6 - 7
4) Choose the communication port to which the RS-232C
cable is connected, and then choose the radio button of
corresponding port on COMMUNICATION PORT
SETTING screen.
5) Click the OK button on the COMMUNICATION PORT
SETTING screen, and then proceed with the MODEL
SELECT screen.
Note:
If the following dialogs appear, perform the
troubleshooting below:
POWER OR CONNECTION ERROR dialog
COM PORT ERROR dialog
When the power or connection error dialog appears:
A connection is incorrect or power is not turned on.
Make sure that all connections are correct and that
power is supplied to the reference data creating
device or DSP-R interface jig.
Clicking the OK button will finish the program:
After solving the problem, restart the program.
When the communication port error dialog appears:
There was a mistake in selecting communication port.
Check the communication port.
Clicking the OK button will finish the program:
Select the communication port again after restart.
MANUAL ADJUSTMENT PROGRAM for SERVICE STATION
MANUAL ADJUSTMENT PROGRAM
for SERVICE STATION
COM PORT SETTING
PORT 1
PORT
PORT 6
PORT 5
PORT 4
PORT 3
PORT 2
OK
EXIT
Copyright (C) HITACHI, Ltd 2003
4
5
COMMUNICATION PORT SETTING
screen
OK
COM PORT ERROR
ERROR
!
OK
MAY OCCURE ON CABLE OR JIG OR CAMCORDER.
POWER FAILURE OR CONNECTION ERROR!
ERROR
!
Adjustment > Creating Reference Data
