35 | 108
E-Compact MP-BB3 Series
4.6.4. Display interface
The Control Module CM9001 has a system of configuration, measurements, alarms, and remote
management (TELESUPERVISION), that controls all of the transmitter modules.
The transmitter configuration can be done either by the front panel of the transmitter or the web interface
using a browser of your choice or SNMP.
This section will show you how to navigate, operate, and configure certain device functions using the
Keyboard and Display Interface. These interfaces allow interaction between system control and the user.
The Interface is composed of a Graphic LCD Display, two alarm management keys: “Fault” AND “Past
Alarm”, two indication LED’s (“Power “On” and “Stream Loss”), and six Navigation keys.
This set allows equipment operation. Through the display it is possible to visualize and change all of the
parameters of the equipment.
The navigation consists of positioning the functions in the display according to the
▶
▲▼
◀
where the “OK”
key triggers the “Menu” or the “Function” selected and the “ESC” key either aborts the changes made or
returns to the next ascending level of the Menu
When holding the “ESC” key for 3 seconds the equipment standby screen is accessed.
When holding the “ESC” key for more than 10 seconds the front panel is reset without affecting the
operation of the transmitter.
Standby screen:
04
05
06
01
08
07
02
03
09
ESC
OK
Summary of Contents for EC702MP-BB3
