Chapter 5 Configuration of Communication parameters
(2) Input items
Input items that can be configured in Ethernet parameters window are shown in Table 5.6.
Table 5.6
Input items of Ethernet parameters window
No
Name
Description
Range for setting
IP Address Set
1)
MAC Address
To confirm the MAC address of EH-ETH2
Confirming only
2)
IP address
To set the IP address of EH-ETH2
Except 0.0.0.0 and 255.255.255.255
3)
Subnet mask
To set the Subnet mask of EH-ETH2
Between 255.0.0.0 and 255.255.255.248
4)
Default gateway
To set the Default gateway address of EH-ETH2
Except 255.255.255.255
5)
Transfer speed / Type To set transfer speed and type
Auto Negotiation (0),
100Mbps Full Duplex (1),
100Mbps Half Duplex (2),
10Mbps Full Duplex (3),
10Mbps Half Duplex (4)
Other station for Diagnosis
6)
IP Address
To set the destination IP address of EH-ETH2’s testing.
Except 0.0.0.0 and 255.255.255.255
7)
Port No.
To set the destination Port number of EH-ETH2’s
testing.
Between 1 and 65535
Task Code Logical Port No. Set
8)
Task Code Port
Timeout
To set the timeout of Task code connection is enable or
not. This value is valid for all Task code connections. If
this is specified as disable, the value of item (9) is not
valid.
Enable (0), Disable (1)
9)
Timeout value
To set the value for timeout of Task code connection and
this unit is second. This value is valid for all Task code
connections.
Between 0 and 65535
Task code port m (m[1:4])
10-m) Port No.
To set the logical port number for Task code connection. Between 1 and 65535
11-m) Protocol
To select the protocol for Task code connection.
TCP/IP (0), UDP/IP (1)
(3) Operation buttons
The window has the five operation buttons shown below.
Table 5.7
Operation buttons of Ethernet parameters window
Name Description
Online
To connect to EH-ETH2. At this time, the present values are overwrtiten in
each input boxes.
Offline To
disconnect from EH-ETH2.
Set
To set the values in the input boxes.
Default Set
To set the default values.
Close
To close the window.
When you click the “Set” button, EH-ETH2 Configurator will check the parameters. If all parameters are
correct, they will be saved into set up file, and the completion massage box will appear. If they are wrong, set
up file is not updated. In this case, please check and correct the value, and set again.
5-9
