56
Chapter 1 Error Codes
6010 9317
The destination volume of the specified volume pair
may contain some inconsistency because volume
copy is not completed yet. Full volume initialization is
required before re-using it.
The same as the message.
W
0
6010 9318
As the result of this operation, you will not be able to
re-start ERASE R-VOL operation.
If you want to delete a pair, even though you
cannot reexecute the P-VOL deletion, select OK.
If not, select Cancel.
W 0
7005 5013
An error occurred. If this problem persists please call
Support Center.
E
2
7005 5099
An error occurred. If this problem persists, please call
the Support Center.
You are trying to set paths to un-installed
volume/volume other than the top of an
expanded LU/Reserve volume of CruiseControl.
The error does not occur normally because it is
guarded in the screen. Contact the program
maker.
E 2
7005 6012
An error occurred. If this problem persists please call
Support Center.
E
2
7005 6023
An error occurred. If this problem persists please call
Support Center.
E
2
7005 8000
A time-out error occurred.
Retry the operation. If you get the same
message again, reboot the PC. If necessary,
please call the Hitachi Data Systems Support
Center.
E 4
7005 8001
A time-out error occurred.
Retry the operation. If you get the same
message again, reboot the PC. If necessary,
please call the Hitachi Data Systems Support
Center.
E 4
7005 8100
A time-out error occurred.
Retry the operation. If you get the same
message again, reboot the PC. If necessary,
please call the Hitachi Data Systems Support
Center.
E 4
7005 8525
Internal logical error.
Contact Hitachi Data Systems Support Center. I
0
7007 6012
An error occurred. If this problem persists, please call
the Support Center.
E
2
7007 7111
An error occurred. If this problem persists, please call
the Support Center.
E
2
7010 5115
The volume of S-VOL is different from specified P-
VOL.
Check the capacity of P-VOL and S-VOL.
Specify a volume with the same capacity, and
retry the operation.
W 0
7010 5116
You cannot create another L1 pair, because the
number of L1 pairs exceeds the maximum.
You cannot create L1 pair for the specified P-
VOL. Delete the created L1 pair, and retry the
operation.
W 0
7010 5117
No MU number is available.
You cannot create the specified pair. Check the
possible number of pairs to be created.
W 0
7010 5118
The MU number is not selected.
Select MU number.
W
0
7010 5119
No P-VOL is selected.
Select P-VOL, and operate.
W
0
7010 5120
No S-VOL is selected.
Select S-VOL, and operate.
W
0
Summary of Contents for Freedom Storage Lightning 9900 V series
Page 1: ...Hitachi Freedom Storage Lightning 9900 V Series Remote Console Error Codes ...
Page 2: ......
Page 6: ...vi Preface ...
Page 8: ...viii Contents ...