--- 8 ---
(6) Removal of the Pushing Button Switch [49] <48>
1. Loosen the Tapping Screw (W/Flange) D4 x 16 (Black) [56] <55> and remove the Tail cover [55] <54>.
2. Loosen the two Tapping Screws (W/Flange) D4 x 20 (Black) [58] <57> and remove the Switch Holder [50]
<49> from the Housing [40] <40>.
3. Pressing the Pushing Button Switch [49] <48> in the arrow "A" direction, press the latches of the Switch
Holder [50] <49> in the arrow "B" direction with a small flat-blade screwdriver to remove the Pushing Button
Switch [49] <48> from the Switch Holder [50] <49> (See Fig. 7).
4. Pressing the button of the Pushing Button Switch [49] <48> in the arrow "C" direction, press the Pushing
Button Switch [49] <48> in the arrow "A" direction to remove the Pushing Button Switch [49] <48>
(See Fig. 8).
8-2.Reassembly
Put the parts together in the reverse order of disassembly, with the precautions given below.
(1) Generously lubricate the teeth of Gear [22] <22> and Pinion [7] <7> with grease. Rub grease onto the teeth
with your fingers so that the grease reaches each tooth bottom. Note that under-lubricated Gear [22] <22>
and Pinion [7] <7> may wear at a faster rate.
Fig. 8
B
Fig. 7
Switch
Switch holder
A
B
A
A
C
Switch
Switch holder
Button
Latches
