33
How to attach the slide door
(Ice Compartment/Upper Freezer/Lower Freezer/Vegetable Compartment)
Ice Compartment/Upper Freezer
Lower Freezer/Vegetable Compartment
Frame
Ice Case
(Ice Compartment)
・
Upper Freezer case
(Upper Freezer)
Draw the door fully and lift up the case towards you.
Put the case bottom on the frame and set the case.
Underside of the case
Frame
Frame
Draw the door fully and pull up
both hands further to pull it out
slowly and to place it on the floor.
Upper Case, Lower Case
(Vegetable Compartment)
To install the Lower Case, put the lugs on the right
and left of the lower case into the square holes on
the frame, and place the fringe of the lower case
on the frame to set.
Wrong setting may cause abnormal noise or half-
closed door when opening or closing the door.
Upper Case
Lift up the Upper Case.
Lift up the Lower Case toward the
front.
●
Do not detach the door completely.
●
When opening the door, do not place your foot near the door. Doing so may
cause it to be caught between the door and the floor.
●
Be careful. Water
may drip from the
backside of the lower
case.
Request
Request
Request
Lower Case
Slide case and lower freezer case
(Lower Freezer)
When installing it, insert the pins on the left/right of the Lower freezer case into the square holes on the frame to install it.
Moreover, hitch the fork on the left/right of the Slide case to the outside of the Lower freezer case.
Slimline slide case
Draw the door fully, and draw the Slide case
respectively.
Lift up the Lower
freezer case.
Slide case
Frame
Seal
Lower
freezer case
●
Do not remove the Slimline slide case.
●
The partition of the Lower Freezer
can’ t be removed.
●
Do not peel off the adhesive
seal.
Caution
Caution
Caution
Partition
Pin (right and left)
Pin (right and left)
Fork (right and left)
Rectangle
hole in the
frame
Rectangle hole in the frame
●
The partition cannot be removed.
●
Improper installation of the Upper Case may damage parts,
including cases. Once the Upper Case is installed, slide it in
the front-rear direction to confirm that it is mounted properly.
●
Do not remove the Moisture Cover and Unit in the Lower Case.
How to Remove/Attach Parts