Setup Process
GR2K-GA-0008
2-11
Rev. 1.00
2.9
The Setup Terminal and Cable Connections
A personal computer or terminal is used to connect to the CONSOLE port on the
GR2000-B to perform initial setup.
2.9.1
Setup Terminal
Prepare a personal computer or a workstation which supports the following features
mentioned in Table 2-1 below.
2.9.2
Connecting Cable
The RS
232C cable, a cross-cable having a D
sub 9-pin (female) on each end, is
required to connect GR2000-B to a setup terminal. Table 2-2 below shows the pin
arrangement of the RS-232C cable.
Table 2-1 Specifications Required for Setup Terminals
Category
Specification
Communication port
RS
232C
Communication software
Hyperterminal utility in Windows 95/98 or other similar
terminal communication software.
Communication
settings
Transfer Protocol
ZMODEM
Parameter
8-bits data, 1 stop bit, no parity
Speed in bps (Note)
19200, 9600, 4800, 2400, or 1200
Other features
CD
ROM drive
Note:
Set to default of 9600 bit/s as shipped from factory.
Table 2-2 Pinout for RS-232C Cable
No.
Router Side: 9 Pins (Female)
Physical Connection
Console Side: 9 Pins (Female)
Pin Number
Signal Name
Pin Number
Signal Name
1
5
SG
5
GND
2
3
SD
2
RX
3
2
RD
3
TX
4
7
RS
1
DCD
5
8
CS
8
CTS
6
1
CD
7
RTS
7
6
DR
4
DTR
8
4
ER
6
DSR
