Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
1-84
GR2K-GA-0014
Ver. 07-02
<DSCP_Value> | precedence <precedence_Value>}] [{upper| lower} <Length>]
[user_priority <No.>]
2. When the high order protocol is TCP, UDP.
{tcp| udp} <IPv6_Source> [<port_source>] <IPv6_Destination>
[<port_destination>] [{dscp <DSCP_Value> | precedence
<precedence_Value>}] [{upper| lower} <Length>] [user_priority <No.>]
3. When the high order protocol is ICMPv6.
icmp6 <IP_Source> <IP_Destination> [<ICMPv6_Type> [<ICMPv6_Code>]] [{dscp
<DSCP_Value> | precedence <precedence_Value>}] [{upper| lower} <Length>]
[user_priority <No.>]
Changing only the operation designation:
[set] flow qos <Interface Name> {in | out} list <List No.> -action
[ {-upc <kbps> [-upc_burst <Byte>]}
| {[-max_rate <kbps> [-max_rate_burst <Byte>]]
[-min_rate <kbps> [-min_rate_burst <Byte>]]} ]
[-index <No.>]
[-replace_user_priority <No.>]
[ { [-priority <No.>][-discard <No.>][{-penalty_drop | -penalty_discard
<No.> | -group <No.>}] }
| { -replace_dscp <DSCP_Value> [{-penalty_drop | -penalty_dscp
<DSCP_Value>}] }
| { -dscp_map [{-penalty_drop | -penalty_dscp <DSCP_Value>}] }]
Deletion of the information
delete flow qos <Interface Name> {in | out} [list <List No.>]
Indication of the information
show flow qos [<Interface Name> [{in | out} [list <List No.>]]]
Indication of a blank list number in the specified range
show flow qos <Interface Name> {in | out} [list <List No.>-<List No.>]
free
Indication of top blank list number in the specified range
show flow qos <Interface Name> {in | out} [list <List No.>-<List No.>]
free min_no
*
Note: 1: If the {normal packet flow detecting condition}, [premium {important packet flow
detecting condition}], and the operation specification (*1) are set or changed
simultaneously, input the operation specification after having input the {normal packet
flow detecting condition}, and [premium {important packet flow detecting condition}].
2: When any parameter in the {normal packet flow detecting condition}, [premium
{important packet flow detecting condition}] must be changed. Input all the flow detecting
conditions and the operation specification again.
*1: If the "flow detecting condition" and the operation designation