Filtering/QoS Information
GR2K-GA-0014
1-93
Ver. 07-02
[user_priority <No.>]
Description:
Specifies user priority. This parameter specify "in"(Inbound)
VLAN line information.
Default:
None
Range of value:
0 -7
Ordinary packet flow detecting condition} [premium {important packet flow
detecting condition}]
When the maximum band restriction (-max_rate) or the minimum band
assurance (-min_rate) is executed, the important packet is transferred with
priority given in the band, and the ordinary packet is transferred when the
important packet is not transferred by using all the bands. This function is called
the important packet assuring function. The flow detecting conditions for the
ordinary packet are inputted before the premium, and the flow detecting
conditions for the important packet after the premium. The flow detecting
conditions for the important packet can be set only after either one of the
maximum band restriction (-max_rate) or the minimum band assurance
(-min_rate) has been set.
The parameters that have not been set in the important packet flow detecting
conditions are subjected to the same conditions as the parameters that have
been set in the ordinary packet flow detecting conditions. For setting the
important packet flow detecting conditions, set only the flow detecting condition
parameters whose detecting conditions differ from the ordinary packet flow
detecting conditions.
When the important packet protecting function is used, the number of entries
used per list becomes two or four entries.(Note 3)
Default:
None. (The important packet protecting function is not used.)
Range of value:
None
Operation Parameters
[-action]
If the operation parameter is either set or changed, please be sure to set this
parameter at the head of the whole operation parameter.
Default:
None (No default is possible when designating the operation.)
Range of value:
None
[-upc <kbps> [-upc_bu st <Byte>]]
Specifies the contract band by kbit/s. Specifies burst size in byte unit. If a value
greater than the line speed is set, no action at breach is taken.
When setting this parameter, it is not possible to set -max_rate, -max_burst, and
min_rate_rate, -min_rate_burst. (-upc_burst is effective only in RP-C and RP-D.)
Default:
None. (No contract band surveillance is executed.)
134
Router Advertusement (NDP)
0
135
Neighbor Solicitation (NDP)
0
136
Neighbor Advertusement (NDP)
0
137
Redirect (NDP)
0
Table 1-51 General IGMPv6 Type Code Number
Type
Name
Code