Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
1-130
GR2K-GA-0014
Ver. 07-02
4. Show all the contents:
5. Show the contents of interface name
ether1
:
6. Delete the definition of inbound of interface name
ether1
:
Related Configuration Object
filter
filter-list
filter-group
ip
ip-address
Precaution
1. A maximum of 512 entries of filter interface information per RP can be created
(maximum interface 256, inbound/outbound per interface).
2. Set filter group information, IP information, and IP-address information before
executing this command.
3. More than one filter group cannot be specified for inbound/outbound on one
interface.
4. If this command is inputted in the cases where changes are made on the IP
routing protocol information, the IP multicast protocol information, and the
MPLS information, and the
apply
command is not being executed, the
apply
subcommand is executed before the command is executed, and the changed IP
routing protocol information, IP multicast routing protocol information, and
MPLS information are reflected to the operation.
(config)#show filter-interface
filter_interface ether1 in filter_group ip2;
filter_interface ether1 out filter_group ip2;
filter_interface ether2 in filter_group ip1;
filter_interface ether3 out filter_group ip3;
(config)#
(config)#show filter-interface ether1
filter_interface ether1 in filter_group ip2;
filter_interface ether1 out filter_group ip2;
(config)#
(config)#show filter-interface ether
filter_interface ether1 in filter_group ip2;
filter_interface ether1 out filter_group ip2;
(config)#delete filter-interface ether1 in
(config)#show filter-interface ether1
filter_interface ether1 out -filter_group ip2;
(config)#