Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
1-134
GR2K-GA-0014
Ver. 07-02
1.2.7
qos-tos-map
Figure 1-8 Range of TOS-QoS Conversion Table Information Control
6. Non-IP protocol QoS control
Non-IP protocol (IPX, Bridge, HDLC, etc.) QoS control is set using three
commands: IPX QoS (
qos-ipx
), bridge QoS (
qos-bridge
), and HDLC QoS (
qos-hdlc
).
These define QoS control for IPX, Bridge, and HDLC protocols, respectively.
1.2.9
qos-ipx
1.2.10
qos-bridge
1.2.11
qos-hdlc
1.2.1
qos
This command sets the use and disuse of flow control. The setting of use and disuse
is enabled when the flow control is set using the old, BSD UNIX-based command
system (
qos-ip-hst
,
quos-ip-hst-group
, or
qos-ip
). The setting of use and disuse in this
command is disabled when the flow control is set using a
flow
command. Set the use
and disuse using a
flow
command when setting the flow control using a
flow
command.
Input Format
Setting information
[set] qos {-no | -yes} [-cops][-wan_length_mode {short | long}]
Modifying information
[set] qos {-no | -yes} [-cops][-wan_length_mode {short | long}]
Deleting information
delete qos
Displaying information
show qos
Parameters
{-no | -yes}
Description:
enable/disable flow control
-no
: disable
Sets from qos-tos-map.
Flow Control (input)
Transmission Control
Fl
ow
D
e
te
c
tio
n
: Control range of this command
Interface
(LINE,DLCI, etc.)
Ro
u
te
S
e
a
rc
h
Priority Determination
TOS Rewrite
Contracted Bandwidth
Monitoring
Queue Control
Flow Control (output)
Fl
ow
D
e
te
c
tio
n
Priority Determination
TOS Rewrite
Contracted Bandwidth
Monitoring