Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
1-164
GR2K-GA-0014
Ver. 07-02
e.
To delete the queue number "two" in the interface names: "office1" and "group
1" that have set the group band control.
Related Commands
qos
qos-queue-list
qos-discard-mode
qos-ip-list
qos-ip-list-group
qos-tos-map
qos-ip
qos-ipx
qos-bridge
qos-hdlc, line, timeslot, ppp, frame-relay, dlci
Precautions
1. This command cannot be used with ATM.
2. When the operating configurations stored in memory are modified, the modified
interfaces will restart. Use caution when logged in through a network.
3. If this command is inputted in the cases where changes are made on the IP
routing protocol information, the IP multicast protocol information, and the
MPLS information, and the
apply
command is not being executed, the
apply
subcommand is executed before the command is executed, and the changed IP
routing protocol information, IP multicast routing protocol information, and
MPLS information are reflected to the operation.
4. This command cannot be set when a -cops parameter is set to qos (QoS
information).
(config)# show qos-interface office1
qos yes {
qos-interface office1 {
group 1 peak_rate 10000 {
traffic 1 constant peak_rate 1000;
traffic 2 guarantee min_rate 4000 peak_rate 8000;
traffic 3 constant peak_rate 2000;
traffic 4 constant peak_rate 3000;
};
group 2 peak_rate 20000 {
traffic 1 guarantee min_rate 8000;
traffic 2 guarantee min_rate 6000;
traffic 3 guarantee min_rate 4000;
traffic 4 guarantee min_rate 2000;
};
};
(config)# delete qos-interface office1 -group 1 -traffic 2
qos yes {
qos-interface office1 {
group 1 peak_rate 10000 {
traffic 1 constant peak_rate 1000;
traffic 3 constant peak_rate 2000;
traffic 4 constant peak_rate 3000;
};
group 2 peak_rate 20000 {
traffic 1 guarantee min_rate 8000;
traffic 2 guarantee min_rate 6000;
traffic 3 guarantee min_rate 4000;
traffic 4 guarantee min_rate 2000;
};
};