Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
1-204
GR2K-GA-0014
Ver. 07-02
2. When
exp
is specified as a flow detection condition parameter by
qos-ip-list,
the
entry is enabled only on in designation. out designation is disabled. The entry is
enabled only on the core router in an MPLS network. The entry and exit edge
routers in an MPLS network are disabled.
3. When
exp
is specified as a flow detection condition parameter by
qos-ip-list
or
-replace-exp
is specified as a flow control parameter, only the interface
designation in RP after RP-C or RP-D is enabled to the IP QoS information. The
interface designation in RP except described above is disabled.
4. If this command is inputted in the cases where changes are made on the IP
routing protocol information, the IP multicast protocol information, and the
MPLS information, and the
apply
command is not being executed, the
apply
subcommand is executed before the command is executed, and the changed IP
routing protocol information, IP multicast routing protocol information, and
MPLS information are reflected to the operation.
Figure 1-12 Effect of QoS Configuration Definition Output Priority in ATM Line
GR2000
NIF=0
Line=0
VPI/VCI=0/33
VPI/VCI=0/32
Group Name: tokyo1
192.168.10.1/24
VPI/VCI=0/34
VPI/VCI=1/32
NIF=1
Line=0
VC Name: tokyo2
192.168.20.1/24
Outbound
Inbound
Outbound
Inbound
NIF=3
Line=0
Inbound
NIF=2
Line=0
Line Name: tokyo3
192.168.30.1/24
GR2000
ATM line
ATM line
WAN line
Ethernet line
Line Name: tokyo4
192.168.40.1/24