Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
1-208
GR2K-GA-0014
Ver. 07-02
Parameters
{ <Line Name> | <DLCI Name> | <VC Name> | <Group Name> |
<Timeslot Name> | <Peer Name> }
Description:
This parameter sets the relevant interface name established in
the bridge interface settings. (Before entering this command,
establish the bridge interface settings.)
Default:
Cannot be omitted.
-priority_class <No.>
Description:
This parameter sets the output priority class. In the case of
output priority control, used as the output priority class. In
the case of bandwidth and round-robin, used as the queue
number.
Default:
4
Range of value:
1-8
-discard_class <No.>
Description:
This parameter sets the queuing priority class.
Default:
4
Range of value:
1-4
Examples
1. Setting parameters:
To set the output priority class 3 and queuing priority class 1 in the interface
named
office1
:
2. Modifying parameters:
To change the queuing priority class of the interface named
office1
from
1
to
2
:
(config)# bridge-interface office1 -spt
(config)# qos -yes
(config)# qos-bridge office1 -priority_class 3
-discard_class 1
(config)# show qos-bridge
qos_bridge office1 priority_class 3 discard_class 1 ;
(config)#
(config)# show qos-bridge
show qos-bridge
qos_bridge office1 priority_class 3 discard_class 1 ;
(config)# qos-bridge office1 -discard_class 2
(config)# show qos-bridge
qos_bridge office1 priority_class 3 discard_class 2 ;
(config)#