Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
1-212
GR2K-GA-0014
Ver. 07-02
Related commands
qos
qos-queue-list
qos-interface
qos-discard-mode
bridge-interface
Precaution
If this command is inputted in the cases where changes are made on the IP routing
protocol information, the IP multicast protocol information, and the MPLS
information, and the
apply
command is not being executed, the
apply
subcommand is
executed before the command is executed, and the changed IP routing protocol
information, IP multicast routing protocol information, and MPLS information are
reflected to the operation.
1.2.12
shaper (shaper transmission information)
This sets shaper transmission information. Three types of queuing modes, outbound
priority control, low latency q weighted fair queuing (LLQ+3WFQ) and
weighted fair queuing (4WFQ), are set in interfaces. It is possible to produce a
maximum of 256 entries per RP.
Input Format
Settings
[set] shaper {-set_default_user_priority|-set_default_user_priority_off}
[set] shaper rate_limited_queueing <VLAN_Name>
[[peak_rate {<kbit/s> | <Mbit/s>M}] {Setting the queuing mode}]
Setting the queuing mode
1. In the case of output priority control:
priority [<Length1> [<Length2> [<Length3> [<Length4>]]]]
2. In the case of low latency q weighted fair queuing (LLQ+3WFQ):
llq+3wfq <Rate1>% [<Length1>] <Rate2>% [<Length2>]
<Rate3>% [<Length3>]
{ 10% | 20% | 30% | 40% | 50% | 60% | 70% | 80% | 90% | 100% }
[<Length4>]
3. In the case of weighted fair queuing (4WFQ):
4wfq <Rate1>% [<Length1>] <Rate2>% [<Length2>]
<Rate3>% [<Length3>] <Rate4>% [<Length4>]
Changing settings:
[set] shaper {-set_default_user_priority|-set_default_user_priority_off}
[set] shaper rate_limited_queueing <VLAN_Name>
[[peak_rate {<kbit/s> | <Mbit/s>M}] {Setting the queuing mode}]
Setting the queuing mode
1. In the case of output priority control:
[priority] [<Length1> [<Length2> [<Length3> [<Length4>]]]]
2. In the case of low latency q weighted fair queuing (LLQ+3WFQ):