Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
2-24
GR2K-GA-0014
Ver. 07-02
6. Deleting parameter
The filtering operation and mode of SAP filtering information in No. 1 are deleted.
Related Commands
ipx
ipx-interface
Precautions
If this command is inputted in the cases where changes are made on the IP routing
protocol information, the IP multicast protocol information, and the MPLS
information, and the
apply
command is not being executed, the
apply
subcommand is
executed before the command is executed, and the changed IP routing protocol
information, IP multicast routing protocol information, and MPLS information are
reflected to the operation.
2.1.8
ipx-filtering
This command filters an IPX packet by setting the IPX filtering information. Filtering
is done before the IPX packet is transmitted.
Input Format
Setting information
[set] ipx-filtering { <Line Name> | <DLCI Name> | <VC Name> | <Peer Name>
| <Timeslot Name > | <Group Name> } { -forward | -drop }
protocol_type
<Number> network <IPX Address> socket <Socket> [-netmask <Mask>]
destination_network <IPX Address> destination_socket <Socket>
[-destination_netmask <Mask>]
(config)# show sap-filtering 1
filter {
type 2111;
server_network 11111111;
port_network 22222222;
forward;
output ;
};
(config)# delete sap-filtering 1 -forward
(config)# delete sap-filtering 1 -output
(config)# show sap-filtering 1
filter {
type 2111;
server_network 11111111;
port_network 22222222;
};
(config)#