Operation Management Information
GR2K-GA-0014
4-23
Ver. 07-02
<mask>
Description:
Specifies the net mask address
Default:
No mask
Range of Value:
Net mask address in dot notation
-ignore -noquery -nomodify -noserve -nopeer -notrust -limited -ntpport
Description:
These parameters, if specified, execute actions below.
-ignore
Ignores all accesses from the specified host.
-noquery
Ignores all the NTP Mode 6 and Mode 7 packets sent from the
specified source. Time service with that source continues.
-nomodify
Allows only referential access from the specified host, using
the NTP Mode 6 and Mode 7 packets.
-noserve
Ignores packets from the specified host other than those of
Mode 6 and Mode 7. As a result, no time service is given to
that host.
-nopeer
Treats the specified host not as a peer.
-notrust
Treats the specified host not as a server for time data
synchronization.
-limited
Accepts only the first-issued time data request from a client
belonging to the specified net. Any other time data request
issued later from the other clients of the specified net is
rejected in accordance with the
clientlimit
parameter
setting.
-ntpport
Accepts only the packets issued from the NTP port.
Default:
When none of the above parameters are specified, “
-ignore
-ntpport
” is assumed by default.
-clientlimit <limit>
Description:
Specifies the maximum number of clients that can access the
same NTP server at a time per network
.
Default:
3
Range of Value:
(
<key>
): 1–4294967295 in decimal
-master [-stratum <int>]
Description:
Specifies the local time server definition and the stratum
setting
. This definition applies when no remote time
server exists in the network to which the router
ordinarily connects.
Default:
On with the stratum setting of 8.
Range of Value:
(
<int>
): 1–255 in decimal.
-broadcastdelay <seconds>
Description:
Specifies the delay time in seconds with which a broadcast or
multicast packet arrives
.
Default:
0.004 when no value is specified
Range of Value:
Less than 1 in fixed-point decimal