Operation Management Information
GR2K-GA-0014
4-33
Ver. 07-02
4.7
Default Configuration Objects
4.7.1
default
Function
Sets the configuration to the user-defined default values with the
set
subcommand,
or displays the default values for the configuration with the
show
subcommand.
Input Format
To display the default values for the configuration information:
show default
Parameter
Following displays a list of items and the parameters supported, which can be set to
be used as it’s initial default values.
Example
Customize the default settings for SNMP and frame relay PVC status notification and
display the results:
Related Configuration Object
None
Precautions
1. You cannot directly customize the default settings of a configuration in use. In
order to customize the default settings of the configuration, create a new
configuration file using the
copy
subcommand, edit the new configuration, and
replace the configuration with the edited file using the
copy
subcommand again.
2. If this command is inputted in the cases where changes are made on the IP
routing protocol information, the IP multicast protocol information, and the
MPLS information, and the
apply
command is not being executed, the
apply
subcommand is executed before the command is executed, and the changed IP
routing protocol information, IP multicast routing protocol information, and
MPLS information are reflected to the operation.
(config)# default -snmp_read
(config)# show default
default {
snmp_read;
};
(config)#
(config)# default -frame_relay_poll_direction dte
default {
snmp_read;
frame_relay_poll_direction dte;
};
(config)#
(config)#