Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
4-48
GR2K-GA-0014
Ver. 07-02
4.7.12
ISDN Information (Japan Only)
Input Format
[set]
default
[ { -isdn_ppp_enable | -isdn_ppp_disable } ]
[ -isdn_ppp_call_direction { both | originate | answer } ]
[ -isdn_ppp_min_connect_timer <Second> ]
[ -isdn_ppp_inactivity_timer <Second> ]
[ -isdn_ppp_connect_restriction_direction { both | originate} ]
[ -isdn_ppp_connect_retry_times <Count> ]
[ -isdn_ppp_connect_retry_interval <Second> ]
[ -isdn_ppp_max_connect_threshold <Minutes> ]
[ -isdn_ppp_channel_type { b | h0 | h1 } ]
[ -isdn_ppp_source_mru <Bytes> ]
[ -isdn_ppp_echo_trial_times <Count> ]
[ -isdn_ppp_echo_success_times <Count> ]
[ { -isdn_ppp_ip_address_negotiation_off |
-isdn_ppp_ip_address_negotiation } ]
[ -isdn_ppp_remote_ip_address_mode { assign | check } ]
VC information
Active/non-active state switching of VC
vc_enable (VC
active state)
Switching of mode in which Inverse ARP of an ATM line is used
or not used
inverse_arp
(Inverse ARP is
used.)
MTU of ATM line
4470 bytes
Setting of cell loss priority display bit
0 (CLP=0)
Polling interval in VC state monitoring function using F5-OAM
loop-back cell (seconds)
no (The VC state
monitoring
function does not
operate.)
Number of response reception confirmation times during VC
failure recovery in VC state monitoring function using F5-OAM
loop-back cell (times)
3 times
Number of non-response confirmation times during VC failure
generation in VC state monitoring function using F5-OAM
loop-back cell (times)
5 times
Request transmission interval during VC failure generation/
recovery in VC state monitoring function using F5-OAM
loop-back cell (seconds)
1 second
*
Note: ISDN settings are only valid in Japan.
Software for using the model GR2000-B overseas currently allows the setting of
ISDN functions. However, since hardware specifications do not support ISDN, a
log message indicating an error is displayed if ISDN configuration definitions are
set. In order to avoid this malfunction, do not set ISDN configuration definitions.
Table 4-11 List of Initial Values That Can Be Set Using ARM Information and Initial
Values During Initial Installation (continued)
Information
Group Name
Information Name
Initial Value