Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
1-10
GR2K-GA-0014
Ver. 07-02
Parameters
[{-no | -yes}]
Description:
Specifies use or no-use of the flow control function.
-no
: Not used.
-yes : Used.mParameter
Default:
no
[{ -classify_all_off | -classify_all }] :
This parameter fixedly specifies the priority of an IPv4 packet that this router
generates or specifies it using a
flow qos
command. It is invalid in RP-A1. In
RP-A1, this parameter operates as classify_all_off. The IPv6 packet that this
router generates is controlled by the priority set using a
flow qos
command
irrespective of the existence of this option.
-classify_all_off :
This parameter specifies the fixed priority in the IP packet that this router
generates. The priority for each packet type when this parameter is specified is
shown in Table 1-8 on page 1-12.
-classify_all:
This parameter specifies the priority, set using a
flow qos
command, in the IP
packet that this router generates. The priority for each packet type when this
parameter is specified is shown in Table 1-9 on page 1-13.
Default:
-classify_all_off
Range of value:
None
[-cops_range <Minimum List No.>-<Maximum List No.>[Ver. 06-03]
Description:
This parameter specifies the range of a flow list number in
which a COPS agent function can be set to all RPs. It cannot
be changed when "cops_yes" is set in the cops configuration
definition. Also, this parameter cannot be deleted when cops
configuration definition is set.
Default:
None (A COPS function is not used.)
Range of value:
1 to 20000 (decimal)
Note 1:
The calculation expression for obtaining RP unit yen and
numeric characters is described below.
Number RP unit entries = <Maximum List No.> - <Minimum
List No.> + 1
An example of calculation for the number of entries is given
below.
For -cops range 1001 - 2000
2000 - 1001 + 1 = 1000
The number of flow list entries that can be set using a COPS
agent function is 1000 in units of RP.
This parameter can set a maximum of 2000 entries per RP.