-9-
• Mounting the valve and felt
• Reassembly of the vibration reduction mechanism (Model H 45MEY only)
(4) Reassembly of the vibration reduciton mechanism (Model H 45MEY only):
Insert the Weight Washer
[29]
, Weight Spring
[37]
, Weight
[38]
, Weight Spring
[37]
, and Weight
Washer
[29]
into the Cylinder Case
[19]
in this order. Mount the Retaining Ring for D52 Hole
[39]
to
the Cylinder Case
[19]
by using a retaining ring puller.
NOTE: Be careful not to pop out the Weight Springs [37] when mounting the Retaining Ring for
D52 Hole [39] to the Cylinder Case [19]. Check that the Retaining Ring for D52 Hole [39]
is properly fitted in the groove on the Cylinder Case [19].
(5) Mounting the valve and felt
(a) Insert the Valve
[92]{89}
into the Crank Case
[91]{88}
. Then mount the Washer M3
[93]{90}
to the
Valve
[92]{89}
.
NOTE: Without the Valve [92]{89}, grease leaks out.
(b) Insert the Felt
[94]{91}
into the specified portion in the Crank Case
[91]{88}
as shown in the figure.
(c) Mount the Back Cover
[64]{61}
to the Crank Case
[91]{88}
and secure them with the Bolt M5 x 16
[65]{62}
.
NOTE: Check that the Washer M3 [93]{90} is fitted in the hole of the Crank Case [91]{88}
before mounting the Back Cover [64]{61}.
[29]
[37]
[38]
[37]
[19]
[29]
[39]
[94][91}
[91]{88}
[93]{90}
[92]{89}
Mounting position of
[94]{91}
