English
14
2. Power switch
Ensure that the switch is in the OFF position. If the plug is connected to a recep-
tacle while the switch is in the ON position, the power tool will start operating
immediately and can cause serious injury.
3. Extension cord
When the work area is far away from the power source, use an extension cord of
sufficient thickness and rated capacity (refer to page 8). The extension cord should
be kept as short as practicable.
WARNING:
Damaged cord must be replaced or repaired.
4. Check the receptacle
If the receptacle only loosely accepts the plug, the receptacle must be repaired.
Consult an authorized electrician to make appropriate repairs.
If such a fautly receptacle is used, it may cause overheating, resulting in firing.
5. Confirming condition of the environment:
Confirm that the work site is placed under appropriate conditions conforming to
prescribed precautions.
6. How to install tool
NOTE: For tools such as a bull point
and a cold chisel, use only
Hitachi genuine parts.
(1)Clean, then smear the tool shank with
the grease (optional accessory).
(2)Pull the tool holder in the direction of
arrow
1
and rotate it in the direction
of arrow
2
(counterclockwise). Fully
insert the tool shank into the hexago-
nal hole of the front cover. (Fig. 2)
(3)Return the tool holder to fix the tool.
NOTE: Remove in the reverse order
for installation.
Fig. 2
1
2
䊳
Tool Shank
Front Cover
Tool Holder
