395
•
Transmitting Serial Data (Asynchronous Mode): Figure 12.5 shows a sample flowchart for
transmitting serial data and indicates the procedure to follow.
Yes
Yes
<End>
Clear TE bit to 0 in SCR
Clear DR bit to 0 and set
DDR bit to 1
TEND= 1
No
Output break signal?
No
Read TEND flag in SSR
All data transmitted?
No
TDRE= 1
Yes
No
Read TDRE flag in SSR
(3)
Initialize
(4)
Write transmit data in TDR
and clear TDRE flag to 0 in SSR
(1)
(2)
(3)
(4)
Start transmitting
(1)
(2)
Yes
SCI initialization:
the transmit data output function of
the TxD pin is selected automatically.
After the TE bit is set to 1, one frame
of 1s is output, then transmission is
possible.
SCI status check and transmit data
write:
read SSR and check that the TDRE
flag is set to 1, then write transmit data
in TDR and clear the TDRE flag to 0.
To continue transmitting serial data:
after checking that the TDRE flag is 1,
indicating that data can be written,
write data in TDR, then clear the
TDRE flag to 0.
To output a break signal at the end of
serial transmission:
set the DDR bit to 1 and clear the DR
bit to 0, then clear the TE bit to 0 in
SCR.
Figure 12.5 Sample Flowchart for Transmitting Serial Data
Summary of Contents for H8/3060
