2
Safety Precautions
！
Please be sure to cut off the main power supply before opening the panel to repair.
Please use specified cable. Connect it firmly to the connection terminals avoiding the shielding.
Do not apply wire stress to these parts. Otherwise it might cause electric shock or fire, etc.
Install the appliance on the base that can support its weight. Otherwise it may cause injury in
the event the appliance falls off the base.
Connect with the electric supply after installation and check electric leakage.
Avoid the following places for installation where
appliance may fail to operate normally:
·
Places with presence of oils.
·
Places where sulfide gas occurs such as hot springs.
·
Places with a
flammable
environment.
·
Salty
places
such
as
coastal regions
.
·
Places with high
temperature
,
electric
signals
or flames
,
which may
lead to
heat
or
fire.
·
Where
there
is
high
-
frequency
or
wireless
equipment
,
which
can
cause
interference.
·
Moisture
or
water
flooding
place.
Once
the
water
enters
inside the wired controller, electric
shock
or
electronic
parts
failure may occur.
Do not install the appliance or connect the wires before reading the manual.
Usage of spray such as pesticides, paint, hair gel or other toxic gases within 1 meter of the
appliance is prohibited.
If the ELB (Electric Leakage Break) or fuse trouble is liable to occur, please consult local
service provider.
Do NOT place any object on the unit that is not related to the appliance. Protect
the
wires,
electrical
parts, etc. from
rats
or
other
small
animals. If
not
protected, rats
may
gnaw at
unprotected
parts
and
at
the worst, a
fire
will
occur.
Firmly connect wires. Excessive force may cause shortcircuit.
If the electric box or fuse break happens frequently, please consult local service provider.
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
Install indoor unit outdoor unit, wired controller or cables at least 3 meters away from high frequency
,
-
electric signal source (such as medical appliance).
Do not tread on products or place anything on it
.
d
Choose a place as described below to install wire controller to let TEMP. sensor work normally.
A place where average temperature in the room can be detected
A
.
.
.
ich
.
B A place wh
is not exposed to direct sunlight
.
.
C Avoid extremely hot or cold locations
d
Do not play with the wire controller.
！
