27
5.4.3. FIRST TIME INSTALLATION
Use this option to load default settings, which had been set at the factory. To install factory settings,
highlight ‘First Time Installation’ menu and press OK key, then you will be asked to confirm deleting all
channels and settings. Selecting YES and pressing OK will delete the channel table. Selecting "NO"
and pressing OK will cancel the operation.
6. MESSAGES
When the
box receives no signal (e.g. the antenna cable is
disconnected), “NO SIGNAL” message is seen on the screen.
When there are no channels stored in the box; the
Channel List menu is not accessible. Channel navigation is
not allowed. Therefore, trying to enter these menus or
navigate the channels will display an error message on the
screen.
7. SPECIFIC FUNCTIONS OF REMOTE CONTROL
When there is no menu active on the screen, each of the keys have specific functions.
OK KEY:
when OK key is pressed Channel list appears on the screen.
RECORD KEY
The programs are recorded at once.
Record time is obtained from EPG automatically. If the program has EPG information, you could
set the timer. If there is no EPG info, press the Record button to set the timer in 30 minutes
periods.
In EPG by pressing the record key, programs are recorded instantly.
LIB KEY:
by pressing this key, you will get to the Recordings Library, which shows you the details of
your saved recordings. By pressing it again, you will exit the Recordings Library.
SUBTITLE :
subtitle key shows/hides subtitles of channel. When the subtitle key is pressed,subtitle
ON/OFF message is displayed.
INFO KEY
When INFO key pressed, and when changing channels the information window is displayed on the
lower part of the screen. The small bar indicates the program duration. On the channel info window
there are
Current event name next event name, and their start and end times.
Program duration bar
Program mode (TV or Radio)
Channel number
Name of the channel
