-H5-2-
5.3 Off Line Test
Power LED
Status LED
Operation
(1)
Set the switch 8 and power on the device. At this moment no
sheets should be put on the Input Tray
(2) When the Status LED blinks slowly put the test sheet (No.
040-7-49 on the Input Tray. The separator lifts up and start
scanning. During scanning the LED becomes off.
When all sheets are scanned the LED brinks slowly.
(3) Error does not make any change.
To recover error, open covers for feed and ejection part and
remove jammed sheets and put sheets on the Input tray.
(4)
When the test is completed power off the device.
5.4 Inline Loop Test
Power LED
Status LED
Operation
(1)
Set the switch 9 and power on the device.
During the Inline Loop test the Status LED blinks fast. If error occurs
the Status LED lit solidly. (Refer to section 2.1)
(2) When the test is completed power off the device.
REV0
10.02.15
Summary of Contents for HT-4139-28
