SPECIFICATIONS
• Audio section
• Video section
• Tuner section
• General
• Remote control unit (RB-DD1S)
(Power amplifier)
Rated output:
Front:
60 W + 60 W
(8W/ohms, 20 Hz ~ 20 kHz with 0.08 % T.H.D.)
Centre:
60 W
(8W/ohms, 20 Hz ~ 20 kHz with 0.08 % T.H.D.)
Surround:
60 W + 60 W
(8W/ohms, 20 Hz ~ 20 kHz with 0.08 % T.H.D.)
Output terminals
Front:
A or B
8 to 16W/ohms
A + B
16W/ohms or more
Center/Surround:
8 to 16W/ohms
(Analog)
LINE input - PRE OUT
Input sensitivity / input impedance:
200 mV / 47 kW/kohms
Frequency response:
10 Hz ~ 50 kHz: +1, –3 dB
S/N ratio:
92 dB (IHF-A weighted)
Total harmonic distortion:
0.08 % (20 Hz ~ 20 kHz)
Rated output:
1.2 V
PHONO input-REC OUT
Input sensitivity / input impedance:
2.5 mV / 47 kW/kohms
RIAA deviation:
±1 dB (20 Hz ~ 20 kHz)
S/N ratio:
74 dB (IHF-A weighted, with 5 mV input)
Total harmonic distortion:
0.03 % (1 kHz, 3 V)
Rated output / Maximum output:
150 mV / 7V
(standard video jacks)
Input/output level and impedance:
1 Vp-p, 75 W/ohms
Frequency response:
5 Hz ~ 10 MHz +1, –3 dB
-15
[FM] (note: µV at 75 W/ohms, 0 dBf = 1 ¥ 10 W)
[AM]
Receiving range:
87.50 MHz ~ 108 MHz (0.05 MHz step)
522 kHz ~ 1611 kHz
(9 kHz step) (E, EBS),
522 kHz ~ 1611 kHz
(9 kHz step) (W, WUN)
520 kHz ~ 1710 kHz
(10 kHz step) (W, WUN)
Usable sensitivity:
1.0 µV (11.2 dBf)
18 µV
50 dB quieting sensitivity:
MONO
1.6 µV (15.3 dBf)
STEREO
23 µV (38.5 dBf)
S/N ratio:
MONO
80 dB (IHF-A weighted)
STEREO
75 dB (IHF-A weighted)
Total harmonic distortion:
MONO
0.2 % (1 kHz)
STEREO
0.4 % (1 kHz)
Power supply:
AC 230 V, 50 Hz (E, EBS), AC 115/230 V, 50/60 Hz (W, WUN)
Power consumption:
180 W
Maximum external dimensions:
434 (W) ¥ 144 (H) ¥ 320 (D) mm
Weight:
7.1 kg
Batteries:
R6P/AA Type (two batteries)
External dimensions:
54 (W) ¥ 172 (H) ¥ 27.2 (D) mm
Weight:
100 g (including batteries)
• Accessory supplied
Operating instructions, Remote control unit (RB-DD1S),
R6P/AA batteries, AM loop antenna and FM indoor antenna
* For purposes of improvement, specifications and design are subject to change without notice.
Summary of Contents for HTA-DD1E
