Travelstar 5K160 (PATA) Hard Disk Drive Specification
96
/
188
the response to an IDENTIFY DEVICE or IDENTIFY PACKET DEVICE command will reflect the reduced set of
capabilities, while the DEVICE CONFIGURATION IDENTIFY command will reflect the entire set of selectable
capabilities.
The format of the Device Configuration Overlay data structure is shown on next page.
14.2.4 DEVICE CONFIGURATION SET (subcommand C3h)
The DEVICE CONFIGURATION SET command allows a device manufacturer or a personal computer system
manufacturer to reduce the set of optional commands, modes, or feature sets supported by a device as indicated by a
DEVICE CONFIGURATION IDENTIFY command. The DEVICE CONFIGURATION SET command transfers an
overlay that modifies some of the bits set in words 63, 82, 83, 84, and 88 of the IDENTIFY DEVICE command
response. When the bits in these words are cleared, the device no longer supports the indicated command, mode, or
feature set. If a bit is set in the overlay transmitted by the device that is not set in the overlay received from a
DEVICE CONFIGURATION IDENTIFY command, no action is taken for that bit.
The format of the overlay transmitted by the device is described in the table at next page. The restrictions on
changing these bits are described in the text following that table. If any of the bit modification restrictions described
are violated or any setting is changed with DEVICE CONFIGURATION SET command, the device shall return
command aborted. At that case, error reason code is returned to sector count register, invalid word location is
returned to LBA High register, and invalid bit location is returned to LBA Mid register. The Definition of error
information is shown on the next page.
ERROR INFORMATION EXAMPLE 1:
After establish a protected area with SET MAX address, if a user attempts to execute DC SET or DC RESTORE,
device abort that command and return error reason code as below.
LBA High
: 03h
= word 3 is invalid
LBA Mid
: 00h
this register is not assigned in this case
Sector count
: 06h
= Protected area is now established
ERROR INFORMATION EXAMPLE 2:
When device is enabled the Security feature set, if user attempts to disable that feature, device abort that command
and return error reason code as below.
LBA High
: 07h
= word 7 is invalid
LBA Mid
: 08h
= bit 3 is invalid
Sector count
: 04h
= now Security feature set is enabled
Word Content
0 0001h
Data
Structure
revision
1
Multiword DMA modes supported
15-3 Reserved
2 1 = Multiword DMA mode 2 and below are supported
1 1 = Multiword DMA mode 1 and below are supported
0 1 = Multiword DMA mode 0 is supported
2
Ultra DMA modes supported
15-6 Reserved
5 1 = Ultra DMA mode 5 and below are supported
4 1 = Ultra DMA mode 4 and below are supported
3 1 = Ultra DMA mode 3 and below are supported
2 1 = Ultra DMA mode 2 and below are supported
1 1 = Ultra DMA mode 1 and below are supported
0 1 = Ultra DMA mode 0 is supported
3-6
Maximum LBA address
7
Command set/feature set supported
15-9 Reserved
8 1 = 48-bit Addressing feature set supported
7 1 = Host Protected Area feature set supported
6 1 = Automatic acoustic management supported
5 Reserved
4 1 = Power-Up in Standby feature set supported
3 1 = Security feature set supported