AU X
T U N E R
UK-7
FUNCTION SELECT
Press the FUNCTION button to change the sound source. The display window will change as below:
RADIO OPERATION
1. Press the FUNCTION button to select the TUNER mode on the unit (or remote control), you can select the radio FM operation.
2. Select the desired frequency with the SKIP/TUNE SEARCH (UP or DOWN) button. Press continuously until you read the
correct frequency or the reception is at its best.
Mono/ Stereo Select
This unit can receive FM mode only.
1. When you want to select FM stereo station, press the REPEAT/MONO/ST. button on the remote control only.
When you receive a FM stereo station the " " indicator will appear on the display window, this means you are receiving
the FM stereo transmission .
2. When you press the REPEAT/MONO/ST. button again, the FM STEREO indicator will turn off and switch to FM MONO
status.
Automatic Tuning
1. Press the SKIP/TUNE SEARCH (UP or DOWN) button for a few seconds, then release the button. The tuner will automatically
search the first station of sufficient signal strength.
2. Repeat above procedure if you wish to select another station.
Programming preset stations
You can also preset stations of your choice and store up 20 FM stations in its memory. To store your selected broadcasting stations:
1. During the unit in TUNER mode, press the SKIP/TUNE SEARCH (UP or DOWN) button to search the required station.
2. Press the MEMORY/CLOCK-ADJ. button on the remote control only.
3. Press the PRESET/ARROW(+ or -) button on the remote control only for your desired station channel.
4. Press the MEMORY/CLOCK-ADJ. button again to confirm your selection.
2. Press and hold the MEMORY/CLOCK-ADJ. button, the HOUR digit will flash. Press the SKIP/TUNE SEARCH(DOWN or UP)
button to adjust HOUR digit firstly. Press the MEMORY/CLOCK-ADJ. button again, the MINUTE digit will also flash. Press
the SKIP/TUNE SEARCH (DOWN or UP) button to adjust MINUTE digit.
3. Press the MEMORY/CLOCK-ADJ. button to confirm the time.
Note: 1. Each enable state as shown above will be cleared if you did not press any buttons in10 seconds.
2. Press CLOCK DISPALY button in any station of Tuner/iPod/Aux when the unit is powered off, the clock will display for
5 seconds and then come back to the original station automatically.