![background image](http://html.mh-extra.com/html/hitachi/l100dn-devicenet-series-addendum/l100dn-devicenet-series-addendum_read-this-first-manual_142290023.webp)
L100DN Inverter
23
Set the Output Frequency
– Note that the standard L100 Series inverter uses parameter
A_01 Frequency Source Setting to select from sources that include a front panel potenti-
ometer and input terminals. In contrast, the L100DN DeviceNet inverter is optimized for
network control and does not have these two alternate frequency sources. Therefore, the
L100DN does not need (or have) parameter A_01. The default frequency source for the
L100DN is setting F_01 Output Frequency Setting. The frequency setting works in the
following way:
• Operator (local) Control – When using the inverter’s front panel Run and Stop keys to
control the motor, the inverter uses parameter F_01 Output Frequency Setting.
• Network Control – When the inverter is under network control, Run and Stop
commands typically arrive via the network. In this case, you have the additional
option of using the inverter’s parameters (includes F_01 Output Frequency Setting), or
the network host device can send the output frequency setting via the network upon
each network scan. More details are in “Network Control and Monitoring” on
page 39.
This step in the powerup test will set F_01 Output Frequency Setting to 15Hz.
CAUTION:
Be sure to set F_01 Output Frequency Setting to a safe value for your motor
and application. The step below only uses 15Hz as an example.
This step concludes the parameter setups for the inverter. You are almost ready to run the
motor for the first time!
TIP:
If you became lost during any of these steps, first observe the state of the PRG
LED. Then study the “Keypad Navigational Map” on page 20 to determine the current
state of the keypad controls and display. As long as you do not press the STR key, no
parameters will be changed by keypad entry errors. Note that power cycling the inverter
will not cause it to reset to a particular programming state.
The next section will show you how to monitor a particular parameter from the display.
Then you will be ready to run the motor.
Action
Display
Func./Parameter
Press the
key.
“A” Group List
Press the
key six times until ->
Output frequency setting
Press the
key.
Default output frequency
Press and hold the
key until ->.
Use the
key also as necessary.
Set to 15.0 Hz, or a safe level
(motor speed) for your applica-
tion.
Press the
key.
Stores parameter, returns to “F”
Group list
FUNC.
A - -
2
F 0 1
FUNC.
0.0
1
2
1 5.0
FUNC.
F 0 1
Summary of Contents for L100DN DeviceNet Series Addendum
Page 96: ......