- 29 -
Playback NTSC
• Connect NTSC VCR player to a SCART socket of
the TV.
• Then, select the related source from the
SOURCE
menu.
Source selection for
VCR
recording.
• Select
Feature
menu.
• Select
AV-2 Out
by pressing
/
button.
• For copying the picture that comes from the tuner,
select SCART 1.
Note
: Scart-1 socket cannot be used as DTV output.
Please use Scart-2 instead.
Camera And Camcorder
To Connect To AV Input
Connect your camera or camcorder to AV input of the
TV.
• Connect your equipment to the TV via
VIDEO
(yel-
low),
AUDIO R
(red) and
AUDIO L
(white) inputs.
You must connect the jacks into the input with the
same colour.
To Connect To S-VHS Input
Connect your camera or camcorder S-VHS input of
the TV.
• Connect your equipment to the TV via S-VHS input
and audio inputs of AV inputs by using S-VHS
cables.
Connect The Decoder To The Video
Recorder
Some video recorders have a special Scart socket
for decoder.
• Connect a
SCART
cable to the
SCART
socket of
your decoder and to the special Scart socket of
your video recorder. Refer to the booklet of your
video recorder.
Connecting Headphones (optional)
Use the stereo headphone socket of the TV, to con-
nect headphones.
Note:
If you want to connect more equipment to your
TV, consult your dealer.
Audio Lineout
To connect the external speakers to your TV, use the
Line Outs of the TV.
Note
: While watching PC or YPbPr sources, Lineout
selection could only be the current source.
Connecting Subwoofer
Use
Subwoofer Out
socket to connect an external,
active subwoofer to the set to give a much deeper
bass effect.
Tips
Care Of The Screen
Clean the screen with a slightly damp, soft cloth. Do
not use abrasive solvents as they may damage the
TV screen coating layer.
Poor Picture
Have you selected the correct TV system? Is your TV
set or house aerial located too close to non-earthed
audio equipment or neon lights, etc.?
Mountains or high buildings can cause double pic-
tures or ghost images. Sometimes you can improve
the picture quality by changing the direction of the
aerial.
Is the picture or Teletext unrecognisable? Check if
you have entered the correct frequency.
The picture quality may degrade when two peripher-
als are connected to the TV at the same time. In such
a case, disconnect one of the peripherals.
No Picture
Is the aerial connected properly? Are the plugs con-
nected tightly to the aerial socket? Is the aerial cable
damaged? Are suitable plugs used to connect the
aerial? If you are in doubt, consult your dealer.
No Picture
means that your TV is not receiving a
transmission. Have you selected the correct button
on the remote control?Try once more.
Sound
You can not hear any sound. Did you perhaps inter-
rupt the sound, pressing the
button?
Sound is coming from only one of the speakers.Is the
balance set to one extreme? See
Sound
menu.
Remote Control
Your TV no longer responds to the remote control.
Perhaps the batteries are exhausted. If so you can
still use the local buttons at the bottom of the TV.
A01-IB-ENG-(L26H01E)-MB22-PANEU-26810W-(RRC1001-2511E)-(BASIC PIP)-10049810-50109125.p65
12.06.2007, 13:26
29
