1. Installation of rubber legs.
Attach the rubber legs to the table by screwing them into the
openings on the table bottom.
2. Installation of ON/OFF knobs, burner heads and trivet & trays.
Place the ON/OFF knob on the gas cook axis and push it firmly
inwards. Set the burner head on the burn body, then place the trivet
& trays on the top plate.
For MPH-310RI, there are two types of trivet & trays and burner
head, respectively. The small trivet & tray and small burner head
should be installed at the center.
Ignition (ON/OFF)
knob
Trivet & tray
1. Install the gas table securing a minimum clearance of
15 cm from the side/back wall and 100cm from the
ceiling.
2. Connect the rubber hose to the gas cylinder
3. Make sure there is no dust on the gas inlet pipe and fit
the rubber hose over the gas inlet pipe, making sure the
end of the hose reaches the line as shown. Fasten the
hose securely with a hose clamp.
Gas inlet pipe
Rubber hose
Hose clamp
l
Do not route the rubber hose under
the gas table.
Do not place any objects that may
easily be blown away by the wind on
the gas table.
l
l
Never use one single rubber hose
for two gas tables.
Keep away flammable material /
liquid from the gas table.
l
Make sure that all knobs of the gas table at the “OFF” position, and open fully the gas stopcock of gas cylinder.
1. Ignition and Flame Adjustment
Push the knob fully and turn counterclockwise to “ON”.
Flame is adjustable between “ON” and “OFF” position
and also between “ON” and position by turning the
knob slowly. Flame is at its highest at “ON” position and
is medium at position.
Push fully
Small
Max
Med
Igniting the burner for the first time may be difficult because of air trapped in the gas hose. Repeat the ignition
procedure several times until the air is purged and the burner is ignited.
2. Extinction
Turn the ignition knob to the “OFF” position. In this position, no gas is supplied and the flame goes out.
Burner head
Rubber leg
Note
Note
Note
Turn counter-clockwise
3
