--- 24 ---
Pull out.
Toward the magazine
Hinge Pin [67]
Cover Spring [58]
Flat-blade
screwdriver
Magazine Ass'y [68]
Fig. 17
11. INSPECTION AND CONFIRMATION AFTER REASSEMBLY
Check that Plunger (B) [45] and Trigger Plunger [51] move smoothly.
Check that there is no air leakage from each part.
While driving staples with an air pressure of 4.5 kgf/cm
2
(63 psi), check that there is no idle driving and
bending of staples.
Recheck the tightening torque of each screw.
Check that Pushing Lever [31] slides smoothly.
Check that the machine will not operate only by actuating Trigger [52]. Also check that the machine will not
operate only by depressing Pushing Lever [31].
Magazine Cover [57]
Mount the Cover Spring [58] facing the
longer arm side toward the magazine.
(b) Reassembly
Disassembly procedures should be followed in the reverse order. Note the following points.
Insert the pointed end of the Hinge Pin [67].
Mount the Cover Spring [58] facing the longer arm side toward the Magazine Ass'y [68] as shown in Fig. 17.
Apply grease to the Shaft Ring [64] and mount it in the 8 mm (.315 ") dia. hole of the Magazine Ass'y [68]
for easy reassembly.
Be careful not to drive the Pin [59] excessively. The Pin [59] is properly driven if it is at the position 0.5 mm
(.02 ") lower than the tail cover.
Push out.
Summary of Contents for N 5008AC
Page 33: ......
