— 15 —
English
(2) Pull the trigger to drive a nail with keeping your face
and hands away from the nose muzzle.
(3) Remove finger from the trigger.
Remove the nailer from workpiece and reposition into
the next pre-punched metal hole.
Repeat same process.
(4) When charge the nail length, remove the all nails in
the magazine.
WARNING
䢇
Keep your finger off the trigger except during
nailing operation, because serious injury could
result if the push lever accidentally contacts you
or others in work area.
䢇
Keep hands and body away from the discharge
area. The nail may bounce from the recoil of
driving a nail, possibly causing injury.
NOTE:
䢇
THIS is a SEQUENTIAL TRIP MECHANISM, and should
be used in accordance with all warnings and
instructions.
䢇
Always handle nails and package carefully. If nails are
dropped, collating paper may be broken.
䢇
After nailing:
1) disconnect air hose from the Nailer;
2) remove all nails from the Nailer;
3) supply 5 – 10 drops of Hitachi pneumatic tool
lubricant into the air plug on the Nailer; and
4) open the petcock on the air compressor tank to
drain any moisture.
