16
English
Metal Hole
mark
Keep the tool vertically when driving.
To avoid the slipping nails, do not push the tool
forward when positioning the
fi
rst nail in metal hole.
Keep the tool vertically and pull backward.
(2) Pull the trigger to drive a nail with keeping your face
and hands away from the nose muzzle.
(3) Remove
fi
nger from the trigger.
Remove the nailer from workpiece and reposition into
the next pre-punched metal hole.
Repeat same process.
(4) When charge the nail length, remove the all nails in
the magazine.
WARNING
●
Keep your
fi
nger o
ff
the trigger except during
nailing operation, because serious injury
could result if the push lever accidentally
contacts you or others in work area.
●
Keep hands and body away from the
discharge area. The nail may bounce from
the recoil of driving a nail, possibly causing
injury.
NOTE
●
THIS is a SEQUENTIAL TRIP MECHANISM, and
should be used in accordance with all warnings and
instructions.
●
Always handle nails and package carefully. If nails
are dropped, collating paper may be broken.
●
After nailing:
1) disconnect air hose from the Nailer;
2) remove all nails from the Nailer;
3) supply 5 – 10 drops of Hitachi pneumatic tool
lubricant into the air plug on the Nailer; and
4) open the petcock on the air compressor tank to
drain any moisture.
000Book̲NR65AK2̲US.indb 16
000Book̲NR65AK2̲US.indb 16
2014/01/09 12:11:03
2014/01/09 12:11:03
