![background image](http://html.mh-extra.com/html/hitachi/nt-65a5/nt-65a5_instruction-and-safety-manual_143183014.webp)
14
English
LOADING NAILS
WARNING
●
When loading nails into Nailer,
1) do not pull trigger;
2) do not depress push lever; and
3) keep Nailer pointed downward.
(1) Pull the nail feeder back and hang it over the roll pin.
Nail Feeder
Roll pin
(2)
1
Insert nail strips one by one from above the
magazine.
2
Slide nails forward in the magazine.
Nail strips
1
2
Magazine
(3)
1
Pull the nail feeder up in backward direction and
remove it from the roll pin.
2
Slide the nail feeder forward until it contacts nails.
Roll pin
Nail Feeder
NOTE:
●
Use nails at least 5 nails remaining.
●
Slide the nail feeder SLOWLY forward.
If the nail feeder is released roughly, it may be stuck
between the magazine and nails, which makes mis-
feeding trouble.
NAILER OPERATION
Read section titled “SAFETY”(pages 3 – 7).
DANGER
●
Operators and others in work
area MUST wear safety
glasses with side shields
which conforms to ANSI Z87.1
speci
fi
cations.
Ordinary eyeglasses do not
provide adequate protection.
WARNING
●
Only person who have read
and understand this MANUAL
should operate the Nailer.
●
NEVER point tool at yourself
or others in work area.
●
Keep
fi
ngers AWAY from
trigger when not driving nails
to avoid accidental discharge.
●
Know and understand what trigger system you
are using.
Please read and understand “Methods of
Operation” below.
●
Inspect the Nailer before operating to determine
actuation system.
Before starting work, check the nailing operation
switching device.
This Hitachi nailer includes a nailing operation
switching device.
Before starting work, make sure that the
switching device is properly set.
000Book̲NT65A5̲US.indb 14
000Book̲NT65A5̲US.indb 14
2018/05/11 10:24:31
2018/05/11 10:24:31