![background image](http://html.mh-extra.com/html/hitachi/nv-83a2/nv-83a2_technical-data-and-service-manual_143230034.webp)
--- 31 ---
(2) Disassembly and reassembly of nail holder, holder shaft, etc.
(a) Disassembly
Pull out the two Pins [82] with a roll pin puller (4 mm dia.). Then Magazine [81] and Magazine Cover [84]
can be removed. Remove Holder Cap [85] and Roll Pin D2.5 x 18 [88] with a roll pin puller (2.5 mm dia.).
Then Nail Holder [87], Holder Shaft [89] and Spring [90] can be removed.
(b) Reassembly
Disassembly procedures should be followed in the reverse order. Note the following points.
When mounting the Holder Shaft [89] to Magazine [81], check that the Spring [90] is inserted between the
concave portion of Magazine [81] and the convex portion of Holder Shaft [89] and then insert the Pin [82].
(See Fig. 16.)
Check that the Feeder Shaft Rings [83] (2 pcs.) are securely inserted into the grooves of the Pins [82]
(2 pcs.). Be careful not to lose the Feeder Shaft Ring [83].
Check the following after reassembly:
The Nail Holder [87] tilts when opening Magazine Cover [84].
The Nail Holder [87] housed in magazine smoothly when closing Magazine Cover [84].
Convex portion of
Holder Shaft [89]
Nail Holder [87]
Spring [90]
Pin [82]
Concave portion
of Magazine [81]
Fig. 16
Summary of Contents for NV 83A2
Page 15: ... 12 Pushing Lever 54 Part NV 83A2 NV 83A Bent Welded Cover 105 ...
Page 46: ......