4-9
Chapter 4
Safety Function
[3]
On the user authentication screen, enter the user
name and password and click Login.
*)
If user registration is not completed, click the user
registration and follow the procedure below.
(1)
Workers who handle the parameters must have
sufficient knowledge of functional safety. If you fully
understand the knowledge of functional safety, click
"Yes".
(2)
Enter the new user name and new password, enter the
same password again as confirmation, and click "Login".
*)
The number of registered users is one. If you register as
a new user, the previous user information will be lost.
[4]
Select whether to upload (read out from P1-FS) the
parameter information set to P1-FS.
If yes, go to [5]. If no, go to [6].
[5]
Enter the password to connect with P1-FS.
* This password is different from the user authentication
password. The factory setting password set to P1-FS is
[password].
[6]
The parameter editing screen is displayed.
Summary of Contents for P1
