EN
4.4 TEMPERATURE SETTING
1
Press “ ” or “ ” to select “Temp”.
2
By pressing “ ” , the temperature is
increased by 0.5
º
C to a maximum of 30
º
C.
By pressing “ ”, the temperature is
decreased by 0.5
º
C.
3
Cooling, Dry, Fan operation: A minimum
of 19
º
C.
4
Heating operation: A minimum of 17
º
C.
?
N O T E
• Depending on the type and setting of the indoor
unit, it may not be possible to set the temperature
by 1ºF (0.5ºC).
• The max./min. temperature may differ depending
on the type of indoor unit.
• Minimum and maximum temperature set-
point limits can be configured by selecting a
cooling lower limit and heating upper limit in the
“Function Selection” mode.
• When the “Automatic Reset of Setting
Temperature” function is selected, the
temperature is automatically returned to the
preset temperature after the temperature set-
point change.
• Contact your distributor for detailed information
about “Automatic Reset of Setting Temperature”
and “Cooling Lower Limit Value and Heating
Upper Limit Value for Setting Temperature”
functions.
4.5 FAN SPEED
1
Press “ ” or “ ” to select “SPEED”.
L
Fan Speed
Low
Cool
Fan Speed
Louver
Temp
Menu
2
By pressing “ ” or “ ”, the fan speed
changes as follows.
A
Auto
High 2
High 1
Med
Low 2
Low
∧
∨
∧
∨
∧
∨
∧
∨
∧
∨
?
N O T E
• During dry operation, the fan speed is
automatically changed to “LOW” and cannot be
changed to another fan speed. (“LOW” is NOT
displayed on the liquid crystal display (LCD) at
this time. The present setting status is displayed
on the LCD.)
• Some of the fan speed settings as “High2” or
“Auto” may not be available depending on the
indoor unit type.
4.6 LOUVER SWING DIRECTION
1
Press “
” (On/Off). Make sure that the
power is ON. Press “ ” or “ ” and select
“Louver”.
2
By pressing “ ” or “ ”, the louver
direction changes as below diagram , and
the direction of different types of louver is
displayed differently.
LCD
indication
Auto-swing
Range for COOL
and DR
Y
Auto-swing range for COOL
and DR
Y
Range for HEA
T and F
AN
Auto-swing range for HEA
T and F
AN
COOL,
DRY
HEAT,
FAN
Operation
PMML0564 rev.1 - 09/2021
6
