Hitachi PC-ARFH2E, Instruction Manual

EN

2.1  INSTALLATION PROCEDURE

1 

Insert the edge of the slotted screwdriver 

into the groove at the bottom of the holding 

bracket, push and turn the slotted screwdriver 

to separate and remove the controller from 

the holding bracket.

(iv) A - Groove part 

B - Approx. 6mm
C - Slotted screwdriver
D - View from the bottom side 
E - Wall mount 
F - Tabs for attachment of the controller

?

N O T E

Do not insert the slotted screwdriver into the tab 

part beside the groove. The tab may be damaged 

and the advanced color wired remote controller 

cannot be installed.

2 

Attach the controller to the holding bracket 

and connect the cable as follows:

•  In Case of Exposing the Controller Cable

Fix the holding bracket onto the wall with 

screws (accessory). (v)
Attach the stopper (plastic band) to the cable 

at the inner side of the draw-out hole.

(vi) B - Cable

C -  Band stopper (Field-supplied)
D -  Draw-out hole

E -  Lead the cable with its sheath peeled 

through the groove

F -  Peel the insulation at the end of the cable 

and clamp the M3 solderless terminals 

(field-supplied)

•  When Using Junction Box

-

Prepare the optional field-supplied 

Implanted Junction Box. 

-

Feed the cable through the conduit tubing 

in the wall.

(vii) G -  Optional M size Junction box with 

4 fixing tabs

H -  Optional S size Junction box with 

2 fixing tabs

I - M4 screws (field-supplied)

-

 Cut away the insulation at the end of 

the cable and  clamp the M3 solderless 

terminals (field-supplied). Connect the 

terminals (J)

3 

Attach the controller body to the mounted 

holding bracket. Be careful not to pinch the 

cable when attaching it.  

4 

After installation, peel away the protective 

film from the LCD screen. 

(viii)

Installation

PMML0577 rev.0 - 09/2021

2