6. Operation
When operating the controller, face the transmitter toward the receiver of the indoor unit and press the switch
for the required operation as described in the item “4. Sending Commands from Controller”.
ATTENTION:
In case that two indoor units are installed side by side, the commands from the controller may be
received by both indoor units. The function to identify each indoor unit not applicable.
The item 5 “ Identifying Indoor Units Side by Side Operation” shall be set if recognition is
required.
Turn OFF the power source completely before performing the dip switch setting for receiver kit.
If not, it may cause an electric shock.
In the case that two indoor units are installed side by
side, the commands from the wireless remote control
switch may be received by both indoor units. The
function, “Identifying of Indoor Units Installed Side by
Side” enables to operate the individual unit correctly
without interfering other unit’s operation. As shown in
the right figure, the indoor units of A and B are set side
by side. In this case, the unit B is set as “Identifying
Indoor Units Installed Side by Side”.
NOTE:
This function is required to set at the receiver side. It
shall be set according to the installation manual of the
receiver kit or the indoor unit.
< Setting of Identifying of Indoor Units Installed Side by Side >
(1) Press and hold “ON TIME” switch and “OFF TIME” switch of the
wireless remote control switch simultaneously for 3 seconds.
The “b” is indicated on the liquid crystal display for 3 seconds.
(2) When the above procedure (1) is performed, only the identified
indoor unit (B unit) operation is available. The indoor unit A does not
correspond to the commands from the identified wireless remote
controller.
< Cancellation of Identifying of Indoor Units Installed Side by Side >
Press the “ON TIME” switch and the “OFF TIME” switch
simultaneously for more than 3 seconds. The “A” is indicted on the
liquid crystal display for 3 seconds.
NOTE:
This function is required to cancel at the receiver side. It shall be
cancelled according to the installation manual of the receiver kit or
the indoor unit.
Indoor
Unit A
Indoor
Unit B
"Identified"
Indoor Unit
"Identified"
Wireless Remote
Control Switch
"A"
"b"
Receiver
Kit A
Receiver
Kit B
5. Identifying Indoor Units Installed Side by Side Operation
Setting of Identified
Indoor Unit
Cancellation of Identified
Indoor Unit
5
