●
Editing/registering data that is different from that being printed 5-28
¡
Be sure to register all print data which is created using "Create messages"
function. After that, the data can be printed by selecting it on print description
screen.
¡
Normally, print data created by "Create messages" function is controlled and
stored separately from data created by print description screen. To apply the same
control of data created by print description screen, re-store data in the timing
shown in table below. At this time, it will take about 3 seconds for each 1 print
data.
No.
Re-storing timing to apply the same control of data made by print
contents screen
1
Timing when ink is stopped.
(When ink is stopped from the circulation control screen, and also
when ink is stopped while Apply key is being displayed, the data
cannot be stored in registration area.)
2
Timing when "Manage messages" function is started.
3
Timing when "Copy data" function is started.
4
Timing when status shifts from off-line to on-line.
5
Timing when power is turned on.
¡
With the "Create messages" function, a maximum of 30 types of print data can be
handled separately from normal control. (In the Select message screen, message
name of these data will be displayed in blue.) However, if the data is restored so
that the same control of print data created by print description screen is applied,
the above limitation is released.
¡
When the "Create messages" function is finished by pressing Back key without
registering print data edited using "Create messages" function, the message
"Unstored Print Data" will be displayed. Press OK key to register data. If Close
key is pressed, screen will return to Auxiliary function menu without registration of
data.
=========
Unstored Print Data
=========
Print data are not yet stored.
Solution Press [OK] to store print data.
OK
Cancel
Close
¡
Once "Create messages" function is set, print data will not be the contents edited
last, which will be new message. Be sure to register the data before finishing the
"Create messages" function.
¡
On-line transmission cannot be done even if there is only 1 print data item
separated from normal control. Perform transmission after changing to on-line
status by manual operation.
¡
When "Create user pattern" is started from "Create messages"screen, overwrite to
already registered pattern cannot be performed: Register in an undefined area.
Summary of Contents for PXR-D
Page 319: ...3S23L1307 3B PXR D E7 HEC ...