14
CONNECT TO THE SMARTPHONE
(CONTINUED)
Set the wireless LAN function as “Yes”
1
Touch
button on the Control Panel to turn on the indicator lamp.
All indicator lamps turn on, and then the current settings are displayed.
2
Touch and hold
for at least 3 seconds until the setting sound (beep) sounds
to light
.
Set the unit pairing mode
1
Open the door of the ice compartment.
2
Touch
button on the Control Panel to turn on the indicator lamp.
All indicator lamps turn on, and then the current settings are displayed.
3
Touch and hold
for at least 3 seconds until the beep sounds to blink
.
Set the names of the unit and
user in the application and
complete the pairing setup.
Move back to the application and wait for a while until
pairing setting is finished.
When finished, set the names of the unit and user, and
complete the setting.
5
6
8
Operate the unit
Operate the unit
Operate the settings of the smartphone
Operate the application
●
The light of indications shall turn off in about 40 seconds for energy savings, but the setting will continue until its cancellation.
Notice
(At the time of purchase)
7
Tap “Next” and
proceed the next
screen
Select “R-KWCK_
＊＊＊＊＊＊
”
on the unit changes from blinking to lighting
Select “R-KWCK_
＊＊＊＊＊＊
(
＊
is alphabet
or number)in the Wi-Fi setting.
When the screen on the right is displayed on the dedicated
application, move to the Wi-Fi setting screen of the smartphone
and select “R-KWCK_
＊＊＊＊＊＊
” .
・
The message “Network not connected” may be displayed, but
proceed as it is.
・
It may take a while for “R-KWCK_
＊＊＊＊＊＊
” to be
displayed.
If it does not appear, redisplay the Wi-Fi setting on the
smartphone or turn off the Wi-Fi setting and then turn it on
again.
Set the names of the unit
and user
Tap “Exit” to complete
the setting
Enter the name within 16 characters.
Half-width symbols, such as “ * ” , “ / ”
and “ ( ” , cannot be used.
Light ON
Touch for
3 seconds
Blinking
Touch for
3 seconds
