43
REFRIGERATOR COMPARTMENT
Changing the height of a door pocket
Adjusting shelves
Opening/closing a door
●
Do not hold the swing
partition to open the
left door while the
right door is open.
Or, you can no longer
open the door.
●
Do not close the
door when the swing
partition folds out.
Or, the door does not
shut completely.
■
Shelves and pockets position can be adjusted according to the size of food and drinks.
Remove the stored items before adjusting the shelves.
■
Shelves are adjustable according to the size of food and drinks.
Remove stored items before adjusting a shelf.
■
4 level adjustment shelf
The L-shaped shelf can be adjusted to 4 levels by moving it up or down or turning it over.
Turn the shelf over and place it on the
holders marked with arrows (
).
Make sure the shelf has been placed
properly by sliding it forward and back
before storing food.
■
To open the door
■
To close the door
■
Reversible Shelf
■
Height adjustable upper/lower shelves
●
Removing the shelf
●
Placing the shelf
■
Height Adjustable Pockets
(Right) (Left)
It can be adjusted to the desired
height.
■
Tube Stand
Small things can be placed vertically
in a neat manner.
Hang it on the edge of each pocket as
you like.
●
If you try to open right and left doors at the same time, you may have a diffi culty in opening them. If that occurs, open either of the doors fi rst, and then open the other.
●
Close the door of the Refrigerator Compartment while the Vacuum Case and, the Multiuse Egg Case are in place. If the door is closed while some of them protrude,
the door, the case or food may get damaged.
●
Too many times of opening/closing of the door, or high humidity around the refrigerator may cause mist on the wall, etc. or frost around the Cold Air Blowout Port.
●
Wipe off spilled water or food soup soon, if any.
●
Do not hang it outside the door pocket.
When closing the door, the door, the
case or food may get damaged.
●
Always use the refrigerator with the 4 level adjustment
shelf and height adjustable upper shelf placed.
The other shelves will come off letting go of the stored
items if disregarded.
Caution
Caution
Caution
Swing partition
Swing partition
Remove by slightly lifting up the shelf.
Remove by slightly lifting up the back
of the shelf and pull forward.
Slightly lift the shelf up.
Turn over, and
Set at either top or bottom level.
Adjust the shelf to the desired height and slide
it until it reaches to the interior wall, then slightly
lift up the back of the shelf and push it in.
(Hitch the forks of the shelf to the parts on the back of the shelf)
Slide the shelf forward until
i t h a s b e e n c o m p l e t e l y
removed.
1
2
Tap-tap
As a normal shelf
Height adjustable upper shelf
Level 1
Level 2 (Factory default setting)
Level 3
Level 4
4 level adjustment shelf
Pattern 1 (Upper)
Pattern 2 (Lower)
Shelf pin
4 level adjustment shelf
Height adjustable upper shelf
1
1
1
2
2
2
3
1
2
3
