These are preset functions
except for
(SA
VE).
Preset can be done if these
buttons are pressed while the
air conditioner is stopped,
however
, the unit will not
function accordingly
.
FUNCTION SELECT
OR
Buttons
Each time when you press,
blinking changes in the
following sequence (page 12,
21, 22, 23):
ON/OFF Button
Use this button to set or cancel
the function selected by the
function selector
.
FUNCTION SELECT
OR
(When the door is open)
MANUAL
CLEAN Button
Starts filter cleaning operation
while the air conditioner
operation is stopped. (Page 32)
F
AN SPEED Button
Press this button to
select fan
speed.
VERTICAL
AIRFLOW
Button
Use this button to swing the
vertical air deflector or to adjust
the angle to your preference.
(Page 24)
HORIZONT
AL
AIRFLOW
Button
Use this button to swing the
horizontal air deflector or
to adjust the angle to your
preference. (Page 25)
SET TIME Button
Use this button to set and
check the current time.
(Page 1
1
)
TIMER Buttons
RESET Button
Press this button after the
batteries are replaced and
when the air conditioner does
not function properly
. (Page 1
1
)
DEUTSCH
FRANÇAIS
ITALIANO
SPANISH
PORTUGUÊS
∂ÏÏËÓÈο
РУССКИЙ
POWERFULL Button
Press this button to start
powerful operation. (Page 18)
MANUAL/AUTO Button
Press this button to switch
between auto/manual
dehumidifying and dry
cool operation. (Page 17)
Four options are available:
Auto, H
i, M
ed,L
ow,and Silent.
DYNAMIC AIR DEFLECTION
Button
Press this button to start
dynamic air operation.
(Page 20)
– 7 –
ENGLISH
10_14SH3_OM.indd 7
10_14SH3_OM.indd 7
2012-2-21 14:51:362012-2-21 14:51:36
•
2
•
T
ake out the anti-mold wasabi
cassette from the aluminium bag.
Do not remove or tear
the aluminium sheet on
the surface nor make a
hole on it.
•
Remove the dust box housing
Dust Box Housing
Dust Box Housing
INST
ALLING ANTI-MOLD W
ASABI CASSETTE
Open the front panel.
•
Do not hold the movable panel
when opening and closing the
front panel.
Front panel
Gripping part
Gripping part
Panel support
•
Hold and lift up the front panel.
•
Push up the panel support until it
clicks to lock it.
Lower the front panel and fix in
position with the panel support.
Install the anti-mold wasabi cassette.
Aluminium bag
Slide the anti-mold
wasabi cassette that
has been taken out of
the wrapper directly
into the Dust Box
Housing.
CAUTION
•
Do not put your face close to the package when
you
open
it.
Y
our eyes or nose may be irritated by wasabi aroma.
•
Do NOT eat.
1
No daily maintenance is required. However
,
the effectiveness of anti-mold wasabi cassette
will be lost after approximately 10 years have
elapsed. Replace the anti-mold wasabi cassette
in such event.
この中に「防カビわさびカセット」が入っています
●製品の取扱説明書を確認して確実に取り付けてください。
●開封時は顔を近づけないでください。
わさびの香り成分で、目や鼻に刺激を感じることがあります。
●「防カビわさびカセット」の表面のアルミシートを
はがしたり、破ったり、穴をあけたりしないでください。
「防カビわさびカセット」の効果がなくなります。
●食べられません。
注
意
CAUTION
•
Do not open the front panel during operation
.
It may interrupt the movable panel to work properly
.
Be sure to stop
the operation first before opening
the front panel.
Anti-mold wasabi
cassette
– 8 –
10_14SH3_OM.indd 8
10_14SH3_OM.indd 8
2012-2-21 14:51:362012-2-21 14:51:36
Handle
Summary of Contents for RAC-10SH3
