1
2
3
4
5
6
7
Maintenance of dust catcher
No daily maintenance is required. However
, filter should be cleaned if the dirt is noticeable due to the
environment in which the air conditioner is used.
Some type of dust may not go in the dust box but be accumulated on the rear surface of the dust catcher
.
It is recommended to check the dust amount on the dust catcher approximately once every 2 years and
clean the dust catcher if it is dirty
.
Stop the operation with the remote controller and unplug
the power
supply
(or turn off the circuit breaker).
Remove the front panel.
(Refer to page 35 on removing the front panel)
Remove the dust catcher
.
•
Remove the dust catcher as
shown
with
arrows.
•
If dust is accumulated at the
inner side of the dust catcher
,
remove the dust with a vacuum
cleaner
.
W
ash with water
.
•
Please wash with water
.
•
If the dirt is stubborn, use a mild detergent and wash with warm
water below 40°C.
•
Dry completely in the shade.
Attach the dust catcher
.
•
Hold the dust catcher for the top face with its side having the lever
facing towards you. Insert and push in the dust catcher in the arrow
direction until it clicks.
Attach the front panel.
(Refer to page 36 on attaching the front panel)
Improper installation of the dust catcher could result in malfunction. Filter cleaning operation can not
be performed properly and the
(CLEAN) indicator blinks.
CAUTION
DEUTSCH
FRANÇAIS
ITALIANO
SPANISH
PORTUGUÊS
∂ÏÏËÓÈο
РУССКИЙ
Turn on the power supply (or turn on the circuit breaker).
– 37 –
ENGLISH
10_14SH3_OM.indd 37
10_14SH3_OM.indd 37
2012-2-21 14:51:552012-2-21 14:51:55
MAINTENANCE (continued)
Maintenance of Ion mist unit
Stop the operation with the remote controller
and unplug the power supply (or turn off the
circuit breaker).
Slowly open the vertical air deflectors using
both hands.
CAUTION
s
Be sure to open slowly using both hands as shown
in the illustration.
Otherwise, it may cause malfunction.
s
Do not use excessive force to move the air deflector
beyond the stopper located below it.
Otherwise, it may cause malfunction.
Remove the dirt on the ion mist unit
with a toothbrush.
噝
Be sure to use a dry toothbrush.
噝
Lightly brushed of
f the dust.
Horizontal air
deflectors
CAUTION
噝
Do not touch the
r
conditione
r is
in operation
High voltage generated at these parts could result in electrical shock.
噝
Do not splash or direct water to the ion
mist
unit
It may cause short circuit or malfunction.
– 38 –
Turn on the power supply.
(or turn on the circuit breaker)
ion mist unit while
the
ai
Ion Mist Unit
1
2
3
4
•
Be s
in th
Oth
•
Do
bey
Oth
10_14SH3_OM.indd 38
10_14SH3_OM.indd 38
2012-2-21 14:51:562012-2-21 14:51:56
Summary of Contents for RAC-10SH3
